Furnace Repair in Chehalis Washington

Over time, your heating system will experience a variety of issues. Some common problems include dirty burner flames, faulty thermostats and broken thermocouples.

If you’re having these problems, then it may be time to call for Furnace Repair in Chehalis Washington. A trustworthy, experienced company will help you solve these problems.

1. Check the Frequency

Furnaces cycle on and off throughout the day to keep your home warm. However, frequent cycling can be a sign that your system isn’t operating as efficiently as it should be.

The number of times your furnace cycles each hour depends on several factors. For example, how well your home is insulated will affect how often it will run. In addition, if your thermostat is placed too close to a heat source or in direct sunlight, it may cycle on more frequently.

The best way to prevent heating problems is to schedule regular maintenance. Professionals can inspect your system and clean it to ensure that all components are working properly. In addition, they can replace the filter and remove any dirt that may be causing your system to overheat. This simple step can save you money on your energy bills and extend the life of your equipment. Performing this maintenance on an annual basis will also help you avoid costly breakdowns and repairs.

2. Check the Temperature

The temperature of a furnace can be measured by using thermocouples housed in protection tubes, pyrometers or other devices. These devices are placed inside the heat exchanger to measure gas and refractory lining temperatures without being affected by ambient air temperatures.

A reputable professional will always use a calibrated thermocouple that is welded directly to the tube skin. This will prevent the thermocouple from drifting or degrading over time and ensure a precise reading.

It is also important to check for conductive dust and corrosive gases around the furnace before testing its temperature rise. These contaminants can damage or short circuit the electrical components inside the unit.

If you want to upgrade your home’s comfort system, consider a ductless mini-split system for a room that lacks ductwork. These systems are energy efficient and much quieter than window air conditioners. They are also safer and more convenient than traditional central air systems. Ask your local American Standard dealer about a ductless system in Chehalis Washington to find out more.

3. Check the Voltage

Furnaces use gas, oil, wood or electricity to burn fuel in the burner to heat your air and distribute it through ducts throughout your home. You can tell you have a furnace in your house rather than a boiler because your heater will be attached to pipes or vents rather than radiators. Look for a data sticker on your furnace to find out its staging, AFUE rating and other information. It may be located on the inside of the unit in a utility closet or on the outside on the unit.

4. Check the Pressure

The pressure switch, located near the draft inducer motor in a gas-forced air furnace, ensures that combustion exhaust byproducts are vented properly. It works by sensing negative pressure created by the draft inducer during startup and shutting down the furnace ignition if this pressure is not sufficient.

Inspect the pressure switch hose ports to make sure they are not obstructed by debris or plugged up. If there are clogs, remove the access panel and use a multimeter to test the switch for electrical resistance (ohms). It should read close to zero, which means that the switch is functioning correctly.

Furnace tune-ups are a great way to save money on utility bills and avoid expensive repairs. In addition to cleaning, lubricating, and inspecting connections and components, furnace tune-ups also check for carbon monoxide leaks which are dangerous and can be deadly. This is another reason why it’s important to choose a NATE-certified Customer Care Dealer. They’re trained to recognize and address potential issues before they cause costly problems.